Learn / Field guide

IPv4: addressing and routing

The Internet Protocol puts a source and destination address on every packet so routers can move it across networks. IPv4 addresses look like 192.168.1.20.

19 IPv4 fields, explained

Field names are the ones Wireshark and TShark use, so you can search for them or use them in display filters.

ip.version

The IP version. 4 means IPv4.

ip.hdr_len

How long the IP header is. Usually 20 bytes.

Why it matters: Longer headers mean IP options are present, which is unusual today.

ip.dsfield

Quality-of-service markings that can ask routers to prioritize this packet.

Why it matters: Many networks ignore or reset these markings.

ip.len

The size of this IP packet in bytes, including its header and everything it carries.

ip.id

An identifier used to reassemble a packet if it gets split into fragments.

ip.flags

Fragmentation flags.

Why it matters: "Don't fragment" asks routers to drop the packet rather than split it; this is used to discover the path's maximum packet size.

ip.ttl

Time to live: how many more routers this packet may pass through before it's discarded.

Why it matters: Each router subtracts one. It stops packets from looping forever, and the starting value hints at the sender's operating system.

ip.proto

Which transport protocol is inside: TCP (6), UDP (17), or ICMP (1).

ip.checksum

A check value that lets routers detect a damaged header.

Why it matters: Captures taken on the sending computer often show wrong checksums because the network card fills them in later. That's normal.

ip.src

The IP address that sent this packet.

Why it matters: Behind a home router, many devices share one public address, so this isn't always one device.

ip.dst

The IP address this packet is going to.

ip.frag_offset

Where this piece belongs if the packet was split into fragments. Zero means it's the first or only piece.

ip.stream

A number Wireshark gives each pair of IP addresses talking to each other.

Why it matters: Generated by Wireshark, not part of the packet.

ip.checksum.status

Whether Wireshark checked the header checksum.

Why it matters: Checksum validation is often off by default because network cards fill checksums in after capture.

ip.dsfield.dscp

A priority marking that asks routers to treat this packet faster or slower.

ip.dsfield.ecn

Explicit Congestion Notification: lets routers signal congestion without dropping packets.

ip.flags.rb

A reserved bit that must be zero.

ip.flags.mf

More fragments: set when more pieces of this packet follow.

ip

An IP header. Inside an ICMP error, this is the header of the packet that caused the error, quoted back to its sender.

Why it matters: Quoting the original header lets the sender match the error to the exact packet it sent.